mohitmishra786/low-level-dev-skills

verilog-basics-for-lowlevel

Verilog basics skill for firmware and kernel engineers.

Ver código fuente

Cómo usar

  1. Copia el comando y revisa el paquete antes de instalarlo en tu entorno de agente.
  2. Consulta las herramientas, credenciales y entornos necesarios en el documento original.
  3. Describe las entradas y el resultado deseado; contrasta la salida con las fuentes.
npx skills add https://github.com/mohitmishra786/low-level-dev-skills --skill verilog-basics-for-lowlevel

Antes de empezar

  • La instalación no incluye suscripción al modelo, cuota API ni permisos sobre tus archivos.
  • Las estrellas e instalaciones reflejan actividad, no una prueba independiente de calidad o seguridad.
Documento original del Skill

Contenido del repositorio de origen con títulos, ejemplos, código, tablas, enlaces e imágenes preservados.

Verilog Basics for Low-Level Engineers

Purpose

Give firmware and kernel engineers enough Verilog/SystemVerilog literacy to read RTL: modules, clocks/resets, combinational vs sequential logic, bus interfaces, and why hardware behavior explains driver bugs — not a replacement for HDL design courses.

When to Use

  • Reference manual unclear — RTL clarifies register behavior
  • Understanding CDC (clock domain crossing) bugs
  • Correlating DMA/AXI transactions with driver ordering
  • Reviewing SoC block diagram with hardware team

Workflow

1. Module structure

verilog
module uart_tx (
    input  wire       clk,
    input  wire       rst_n,   /* active-low async reset */
    input  wire       start,
    input  wire [7:0] data,
    output reg        busy
);
    /* sequential logic */
    always @(posedge clk or negedge rst_n) begin
        if (!rst_n)
            busy <= 1'b0;
        else if (start)
            busy <= 1'b1;
        /* ... */
    end
endmodule

wire = combinational/network; reg in always block = flip-flop unless combinational always @(*).

2. Synthesizable subset (what firmware folks need)

ConstructMeaning
posedge clkRegistered update
assign x = a & bCombinational
case / if in always @(*)Mux logic
Parameters #(.WIDTH(32))Configurable width

Avoid #delay in synthesizable RTL — simulation only.

3. Reset discipline

  • Async assert, sync deassert common (rst_sync_n)
  • Firmware must wait post-reset setup times — see RM reset chapter
  • Multiple reset domains → peripheral may need explicit soft reset bit

4. Bus protocols (reading SoC diagrams)

BusTypical use
APBSlow peripherals, simple reg interface
AHBHigher throughput on-chip
AXIDMA, modern SoCs — bursts, channels

Linux regmap MMIO maps to APB/AXI slave decode in RTL address map.

5. Clock domains

Signals crossing clk_a → clk_b need synchronizers (2+ FFs). Metastability causes intermittent firmware bugs — not fixed in software alone.

6. Simulation vs silicon

bash
# Typical open-source sim (conceptual)
iverilog -o sim.vvp design.v tb.v
vvp sim.vvp

QEMU/peripheral models may not match RTL edge cases.

7. Agent usage

/verilog-basics-for-lowlevel Explain this APB register block and when STATUS bit updates relative to WRITE

Common Problems

SymptomCauseFix
Bit toggles oncePulse in RTLPoll latch / clear-on-read in driver
Random corruptionCDCHardware synchronizer; don't hack delays
Read stale dataBus bridge bufferFollow RM ordering / barrier
IRQ stuckLevel vs pulse in RTLMatch handler ACK sequence
Verilog vs VHDLMixed SoC docsFocus on interface signals table

Related Skills

  • skills/baremetal/mmio-and-bit-manipulation — register access from C
  • skills/baremetal/peripherals-from-datasheet — RM ↔ RTL
  • skills/baremetal/datasheet-and-refmanual-reading — doc navigation
  • skills/kernel-dev/device-tree — hardware integration in Linux
  • skills/qemu/protocol-analysis — validate bus timing

Relacionados por tarea

del mismo repositorio

Más Skills

Todos los Skills
mohitmishra786
Comunidad

low-power-embedded

Low-power embedded skill for sleep modes and energy optimization. Use when configuring MCU sleep/stop/standby, peripheral clock gating, wake-up sources, or measuring firmware current draw. Activates on queries about WFI, STOP mode, STM32 PWR, nRF sleep, wake-up EXTI, or reducing embedded power consumption.

Instalaciones / 1h
1
GitHub Stars
296
Actualizado
20 nov
mohitmishra786
Comunidad

core-dumps

Core dump analysis skill for production crash triage. Use when loading core files in GDB or LLDB, enabling core dump generation on Linux/macOS, mapping symbols with debuginfo or debuginfod, or extracting backtraces from crashes without re-running the program. Activates on queries about core files, ulimit, coredumpctl, debuginfod, crash triage, or analyzing segfaults from production binaries.

Instalaciones / 1h
2
GitHub Stars
267
Actualizado
27 jun
mohitmishra786
Comunidad

custom-allocators

Custom allocator skill for memory allocation strategies. Use when implementing pool/slab/arena allocators, tuning jemalloc/mimalloc, writing Rust GlobalAlloc, or benchmarking allocator performance. Activates on queries about jemalloc, mimalloc, tcmalloc, arena allocator, GlobalAlloc, or fragmentation.

Instalaciones / 1h
2
GitHub Stars
267
Actualizado
27 jun
mohitmishra786
Comunidad

ebpf

eBPF skill for Linux observability and networking. Use when writing eBPF programs with libbpf or bpftrace, attaching kprobes/tracepoints/XDP hooks, debugging verifier errors, working with eBPF maps, or achieving CO-RE portability across kernel versions. Activates on queries about eBPF, bpftool, bpftrace, XDP programs, libbpf, verifier errors, eBPF maps, or kernel tracing with BPF.

Instalaciones / 1h
2
GitHub Stars
267
Actualizado
27 jun